Asgard posted an update on his power charger and supply regulator project we covered previously, the BLiVIT: Testing continues. I have validated the power flow switches and the battery charger/management.The measured idle current draw from the Li+ cell is 23.4uA. With the Powah-1 module and the 10Meg load resistance inherent in my scope the current […]
Tag Archives: BLiVIT
BLiVIT case
Asgard posted pictures of his BLiVIT case we covered earlier.
BLiVIT case design
Asgard posted a case design for the BLiVIT project we covered earlier: This photo is a rendering of the new case design for the BLiVIT. It should have enough vertical clearance for the entire BLiVIT maximum assembly, that being the BLiVIT board, the P01-114 POQiRX transmitter daughter board, the Li+ cell, and the POQiRX transmitter coil […]
Yet another project: P01-114C POQiRX
Here’s another project by Asgard the POQiRX: This board is the optional 25.4 x 22.6 mm add-on board for the P01-109 BLiVIT. It mounts on the header provided on the BLiVIT, and is supported by header pins at the four corners. This board contains a Wireless Power Consortium receiver compliant with the Qi specification. By […]
P01-112 Powah project
Asgard posted his Powah, a little power on/off toggle with an indicator LED in the project log forum: This is a “standard” module I use for some of my other projects (see the BLiVIT thread). This version is a simple CMOS-level on/off toggle with debounce. The optional four pin positions just happen to lay […]
Power charger and supply regulator
Asgard shared his BLiVIT project in the forum: One of the things I have noticed missing, for a pretty long time, is a good *safe* lithium cell charger that also supplies a load with a good efficient regulator. My answer, I hope is the BLiVIT. This is a moderate-sized board that incorporates charging from either […]