3D printed case for Bus Blaster v4


dretay made a 3D-printed Bus Blaster v4 case:

A basic enclosure for the Dangerous Prototypes Bus Blaster v4. The enclosure needs to be the full height of the programmer due to the jumpers. In the future I may trim down the jumpers on my board and use a thinner case that exposes more of the JTAG header. I’ve included the 123Design source file in case you’d like to modify it further.

More cool DIY cases here.

Leave a comment

Your email address will not be published. Required fields are marked *

Notify me of followup comments via e-mail. You can also subscribe without commenting.