Categories

Organic Bus Blaster case

Posted on Monday, November 19th, 2012 in Bus Blaster, cases by DP

Bkubicek made a 3D-printed Bus Blaster case:

Its a case for the v2.5 Bus Blaster. My first attempt to nurbs surfaces using rhino.

Bus Blaster v2 is an experimental, high-speed JTAG debugger for ARM processors, FPGAs, CPLDs, flash, and more.

Via the forum.

More cool DIY cases here.

You can get a Bus Blaster v2 for $34.95.

This entry was posted on Monday, November 19th, 2012 at 1:00 pm and is filed under Bus Blaster, cases. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Organic Bus Blaster case”

  1. And, it looks a bit like van Gogh’s Starry Night..

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Drone: Gee, just the sight of one of these HP493A TWT laboratory amps brings back decades-old memories. There are four models covering 1-12.4 GHz in steps...
  • KH: After reading all the comments, I have questions: Does this mean STM32 and AVR boards/parts from dodgy online sellers are suspect? What are your opinions?...
  • Sjaak: They are available with more flash then their ST counterparts which makes them more interesting. You don't have to port the code, but use another...
  • Sjaak: I dunno if you can 'license' register definitions, but I'm not a lawyer. Since the chip is available since 2015 and I haven't heard of...
  • Sjaak: They can be found on taobao or the Chinese markets in Shenzhen.