Categories

Workshop Update for May 18th, 2012

Posted on Friday, May 18th, 2012 in Workshop Update by DP

Today we’re is setting up our booth at the Bay Area Maker Faire, and digesting all the tacos from yesterday’s Dangerous Taco Crawl 2012.

Firmware for the Part Ninja is making progress. It is now capable of figuring out the part, and its pinout, with consistency. There’s still some calibration to be done, but all in all we are close to the first test release.

In the office we continue working on our regular bookkeeping and filing in preparation for quarter 2 estimated taxes. We also prepared the free PCB codes for today’s winners.

This entry was posted on Friday, May 18th, 2012 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Workshop Update for May 18th, 2012”

  1. Kawa says:

    A full size image would have been nicer :)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please