Categories

Rework and probe wires for circuit boards

Posted on Thursday, November 23rd, 2017 in how-to, techniques by DP

Tips & tricks to add probe wires for low-voltage, low-current signals on small fine pitch circuit boards.

Via Electronupdate.

This entry was posted on Thursday, November 23rd, 2017 at 1:35 pm and is filed under how-to, techniques. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please