Categories

Laser cut cases for Bus Pirate and Logic Pirate

Posted on Thursday, March 19th, 2015 in cases by DP

IMG_20150318_184358_preview_featured

Chase made custom 3D printed/laser-cut cases for the Bus Pirate and Logic Pirate. These cases are up on  Thingiverse.

See other cases too.

Thanks Chase! Via the contact form.

This entry was posted on Thursday, March 19th, 2015 at 10:30 pm and is filed under cases. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please