Categories

Diode temperature sensor calibration using Arduino and SHT15 module

Posted on Monday, January 13th, 2014 in how-to, sensors by DP

cal_setup1

Paulo writes:

A simple diode or the output of a transistor bias circuit can be used as a rough temperature sensor. For this purpose, a calibration procedure using a precise temperature sensor is recommended. This article shows how to calibrate such a temperature sensing circuit using an Arduino and the SHT15 Sensirion temperature/humidity sensor module.

This entry was posted on Monday, January 13th, 2014 at 9:00 pm and is filed under how-to, sensors. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Diode temperature sensor calibration using Arduino and SHT15 module”

  1. atalax says:

    Does this work with LEDs? If yes, does this mean we have temperature AND light sensor AND light emitter in one? No way, gonna have to try this one :)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Stennly: Despite the popularity of STM32s, it may not be the best place to start. As mentioned already, the Silicon Labs gecko family is cheap to...
  • Helge: Silicon Labs offer a powerful, unrestricted and completely free software development kit packaged with their Simplicity Studio IDE. It's built on Eclipse, and includes hundreds...
  • Sjaak: With development kit I ment software development kit. I couldn't (easily) find one back some time. Then I asked around and finally came up with...
  • Pranav gulati: I probably couldn't understand what you meant by ' ST doesn’t offer a development kit as I expected' There are numerous eval boards of STM32...
  • DP.: fixed, thanks