Workshop Update for January 31st, 2013

Posted on Thursday, January 31st, 2013 in Workshop Update by DP


We received tools and tested the reflow oven and hot plate. Added a tools section to the forum, you can get the PDF versoin of the reflow oven manual there. The workshop video of the tool unboxing was made.

We purchased an air-compressor for the solder paste dispenser, and got to clear almost all back mail.

We implemented the UART debugging mode for the Bus Pirate v4 we talked about yesterday. All you need to do is add ‘#define BPV4_DEBUG’ to the ‘base.h’ file, and your next Bus Pirate v4 compile will transfer the communication from the USB to the UART on the AUX1 and AUX2 pins.

This entry was posted on Thursday, January 31st, 2013 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Workshop Update for January 31st, 2013”

  1. Nick Johnson says:

    I like the prose format of this workshop update. Easier to read than bullet points.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?
  • Glenn: What a cool idea !