Workshop Update for December 7th, 2012

Posted on Friday, December 7th, 2012 in Workshop Update by DP

We finalized 6 new designs and sent off a box of PCBs. Several test a new header-less programming pad we’re working on.

We researched various feeder mechanisms for pick n place machines, and posted about them. Which also provided some material for app notes.

The protoboards received another update. We added mini USB B breakouts to all of them. We’re also working on a smaller header-less programing footprint for our boards.

This entry was posted on Friday, December 7th, 2012 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

10 Responses to “Workshop Update for December 7th, 2012”

  1. Matseng says:

    Have you seen this alternative for a isp/icsp header?

    It’s using a spring loaded “solo stacker” connector – good for just flashing new firmware onto the board but a real pain if you need hook up the board for a longer In Circuit Debugging session…

  2. Arup Basak says:

    I have two suggestions for this proto board’s next revision.

    1. Add a micro-USB footprint just in the opposite side of the mini-USB. It will be good addition.

    2. Add a place to use SMD7050/3225/6035 crystal/oscillators.

  3. Sleepwalker3 says:

    Oh goodie! I suggested the USB somewhere else in another post, so I’ll give myself a little gold star for that LOL :D
    I’m assuming that this holes around the outside of the QFP match your other QFP-Header boards, so that we could fit a different pitch QFP if necessary by using a daughter board?

  4. Sleepwalker3 says:

    Well 0.65mm is handy too, looks like a useful board :)

  5. Sleepwalker3 says:

    Is this board likely to be available through Seeed and if so, could you give me an idea of when?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: Using an alkaline coin cell down to 1.0V or under is a very bad idea anyway, unless you as the designer or manufacturer don't care...
  • KH: Farnell says TS1001 is no longer stocked. Not on RS. Digikey says it's obsolete. That said, there are a lot of nanoamp-class parts on sale...
  • Peter: Sunday--
  • Chris Brightly: Best of luck to all, including the wayward prototypers yet to post!
  • Wolfi: o/