App note: EIA surface mount tape standard

Posted on Saturday, December 8th, 2012 in app notes by DP

Here is a paper from the Electronic Industries Alliance describing the standards for surface mount tape. We found it interesting that all surface mount tapes use the same pitch and diameter of the holes in the feeder mechanisms. The pitch being 4mm, and the hole diameter 1.5mm.

Via Outguessing the machine.

This entry was posted on Saturday, December 8th, 2012 at 1:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “App note: EIA surface mount tape standard”

  1. Sleepwalker3 says:

    Does anybody know somebody who sells the sprockets as a standard part? I imagine somebody must be making them as a standard part.

  2. Sleepwalker3 says:

    Cool, thanks for that :)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!