Categories

Precise control of DC motors using an FPGA

Posted on Tuesday, September 25th, 2012 in FPGA by DP

Chris wrote extensive documentation on how to implement precise control of DC motors using FPGAs.

The goal of this project is to build a simple one input, one output system that will control a motor. The control input will come from a trimpot and the FPGA or CPLD’s job will be to use the input to create the proper duty cycle PWM output to the DC motor controller.

Via the Gadget Factory.

This entry was posted on Tuesday, September 25th, 2012 at 9:00 pm and is filed under FPGA. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Precise control of DC motors using an FPGA”

  1. jalela balkrushna says:

    thanks

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...