Categories

Ultra-small vusbtiny AVR programmer

Posted on Monday, December 19th, 2011 in project logs by DP

Philip wanted to make the smallest vusbtiny AVR programmer possible. His design incorporates both an edge PCB and a mini-B cable connector for the USB.

Vusbtiny is a AVR programer based on the V-USB virtual low-speed USB firmware. V-USB is a software USB engine for AVR devices that don’t have hardware USB serial interface engines.

Phillip also designed a cable version of this project that is available on his site.

Via the forum.

This entry was posted on Monday, December 19th, 2011 at 10:00 pm and is filed under project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Ultra-small vusbtiny AVR programmer”

  1. GinPB says:

    Awesome, good job.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...