Categories

Posts Tagged ‘GPIB’

GPIBUSB Adapter update

Tuesday, July 8th, 2014

Another update on Scasagrande's project, GPIBUSB Adapter rev4: After working closely with a few individuals it was discovered that some of the pre-existing GPIB software (such as KE5FX's tools) has some hardcoded serial port settings, one of which being the use of hardware flow control. After getting builds of the software...

Tags: , ,
Posted in open source, USB | 2 Comments »

Open source hardware GPIB USB adapter update

Monday, March 17th, 2014

Steven Casagrande posted an update on his open source hardware GPIB USB adapter: After many days, I just finished off firmware version 5 for my adapter. This is probably my biggest update yet. A lot of people asked for compatibility with the Prologix commands so that's what I focused on. Here...

Tags: , ,
Posted in open source | 3 Comments »

How to use GPIBUSB adapter

Monday, January 20th, 2014

[embed]http://www.youtube.com/watch?v=VzGDldTVSOg[/embed] A followup to the GPIB USB Adapter. Steven demonstrates how to  use his adapter in two different software environments the Ubuntu 13.10 + Python + InstrumentKit and the  Win7 + Terminite. Via the forum.

Tags: , ,
Posted in project logs | No Comments »

Open source hardware GPIB USB Adapter

Monday, January 13th, 2014

scasagrande shared his GPIBUSB Adapter rev3 in the project log forum: This past weekend I finally finished up the third major revision of my GPIBUSB adapter board. Major hardware changes include swapping the pull-up resistors for the proper GPIB line drivers, as well as swapping the FT232RL for the newer FT230X. There...

Tags: , ,
Posted in project logs | 14 Comments »

P01-118 GeePibber project

Friday, April 12th, 2013

Asgard shared another project the GeePibber, an IEEE-488 (GPIB / HPIB) to USB adapter in the project log forum: This project is an IEEE-488 (GPIB / HPIB) to USB adapter. I need this because I recently acquired an ancient (but so am I) logic analyzer/oscilloscope which uses only the GPIB to...

Tags: ,
Posted in project logs | 14 Comments »

Recent Comments

  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...
  • KH: Someone with a PIC16F1459 project, well you don't see these every day. Methinks he repeats the USB 2.0 thing too much; this might mislead people...