Categories

Posts Tagged ‘Flash Destroyer’

Turning your Flash Destroyer into a clock

Tuesday, February 18th, 2014

voidptr writes: So ! .... 2 years later, here an update on living with my dangerous Flash Destroyer hack ! First off, front and back picture :o) I added few things since its birth ... A battery for the real time clock, really handy when you reprogram code and you...

Tags: , , ,
Posted in hacks | No Comments »

Turning your Flash Destroyer into a clock

Monday, January 9th, 2012

Ok, so you burned all the memory chips you had around, and now a nice 7-digit display is standing on your desktop just taking up space. This hack turns your unused Flash Destroyer into a clock using a real time clock IC and some spare logic. Via the forum.

Tags: , , ,
Posted in hacks | No Comments »

Flash Destroyer free PCB build

Thursday, September 29th, 2011

znanev built a free Flash Destroyer PCB. After 13 days elapsed, the counter was still ticking and the EEPROM survived over 7 million writes. I wanted to capture the precious moment of the display showing all 7s, but again I had no luck...After 19 days since the start, I found...

Tags: ,
Posted in builds | 1 Comment »

Week in (p)review, June 13, 2010

Sunday, June 13th, 2010

Here's some highlights from the past week, in case you missed them: On Monday the EEPROM in the Flash Destroyer died with 11,494,069 total write-verify cycles. For a closer look at the  failure, and the live stream viewing statistics, see the Flash Destroyer wrap up. It took three tries to...

Tags: , , ,
Posted in week in review | No Comments »

Free PCB Sunday: Flash Destroyer

Sunday, June 6th, 2010

We go through a lot of prototype PCBs, and end up with lots of extras that we’ll never use. Every Sunday we give away a few PCBs from one of our past or future projects, or a related prototype. PCBs are made through Seeed Studio's Fusion board service. This week...

Tags: , ,
Posted in Flash Destroyer, Free PCBs | 16 Comments »

Free PCB Sunday: Flash Destroyer

Sunday, May 30th, 2010

We go through a lot of prototype PCBs, and end up with lots of extras that we’ll never use. Every Sunday we give away a few PCBs from one of our past or future projects, or a related prototype. PCBs are made through Seeed Studio's Fusion board service. This week...

Tags: , ,
Posted in Free PCBs | 25 Comments »

Recent Comments

  • Cody: Yes please
  • Edward Mallon: I've been oversampling those thermistors with the ADC and some pin-toggle noise for a while now, and that method is good. But lately I've been...
  • Marko: armature -> amateur
  • Crawford: Dibs,
  • bill: a sunny Sunday here