Categories

Tiny particle sensor node with decorative case

Posted on Wednesday, March 13th, 2019 in R-Pi, sensors by DP

lucky-resistor-7

Lucky Resistor published a new build:

This article is about a small sensor node with a decorative case. It is based on the Raspberry Pi Zero W board with a custom sensor shield on top.
I publish all hardware files for a simple version of the sensor, so you should be able to build this kind of sensor nodes and use it to monitor anything you like. You can also extend/modify the design easily with additional sensors. Nevertheless, the case lid design is based around the Plantower PMSA003 particle sensor. It has all required air vents for this use.

More details on Lucky Resistor homepage.

This entry was posted on Wednesday, March 13th, 2019 at 11:00 am and is filed under R-Pi, sensors. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please