Adjusting clock with alarm, hygrometer & thermometer on 1.8″ ST7735 display

Posted on Friday, December 2nd, 2016 in Arduino, clock by DP


Nicu Florica blogged about his adjusting clock with alarm, hygrometer and thermometer on 1.8″ ST7735 display:

I use feature from article Another adjusting clock with alarm & thermometer using DS3231 on 1.8″ ST7735 display and change reading internal temperature of DS3231 with DHT22 senzor (AM2302), but you can use a cheaper and not very precise DHT11 senzor.
By using educ8stv_rtctft160_alarm_dht.ino or much better educ8stv_rtctft160_alarm_eeprom_dht.ino sketch, on display you can see: name of day, date, hour clock, hour alarm, temperature and humidity

Project details at Arduinotehniq blog.

Check out the video after the break.

This entry was posted on Friday, December 2nd, 2016 at 12:17 am and is filed under Arduino, clock. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Stephen Tinius: Thank you.
  • KH: Ah, the site sells boards, that's the reason. At least it's a XC6SL9 board that does not cost an arm and a leg, though it...
  • Max: While I understand this is more educational than practical in nature, I prefer my edutainment a lot more firmly grounded in economic reality. Sure, you...
  • KH: Using an alkaline coin cell down to 1.0V or under is a very bad idea anyway, unless you as the designer or manufacturer don't care...
  • KH: Farnell says TS1001 is no longer stocked. Not on RS. Digikey says it's obsolete. That said, there are a lot of nanoamp-class parts on sale...