Categories

A CNC pickup winding machine built on an ATmega8

Posted on Friday, June 3rd, 2016 in DIY by DP

diy_CNC_guitar_pickup_winding_machine-600

Davide Gironi blogged about his DIY ATmega based CNC pickup winding machine:

A pickup winding machine it is used to wind a guitar pickup.
You can find my previous ATmega manual pickup winding machine here
This project is a manual / CNC pickup winding machine, built on top of an ATmega8 microcontroller.

More details at Davide Gironi’s blog.

Check out the video after the break.

This entry was posted on Friday, June 3rd, 2016 at 12:43 am and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: A teacher friend asked us for faster build that was less dependent on soldering because they didn't have the budget for that kit. So we've...
  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.