Categories

OpenCdNC – CNC project made from CD-Rom drives

Posted on Thursday, July 17th, 2014 in DIY by DP

OpenCdNC-CNC-Project-Made-from-CD-Rom-Drives_2

Leonardo made this DIY CNC machine from CD-Rom drives, that is available at Github:

Hardware
1x Microchip PIC16F628A
3x Easy Driver v4.4 Step Motor Driver
1x PL2303HX USB-Serial TTL Converter
3x CDROM Drives
Some wood/screws for frame and wires for electronics

Via Hacked Gadgets.

Check out the video after the break.

This entry was posted on Thursday, July 17th, 2014 at 11:27 am and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “OpenCdNC – CNC project made from CD-Rom drives”

  1. Hert says:

    Really nice project but no diagram?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please