Categories

SX1278/SX1276 (RFM98W/RFM96W) LORA module

Posted on Thursday, July 17th, 2014 in ARM by DP

rfm98w-3

x893 writes:

Simple LORA RF module with RF96W/RF98W (HopeRF) and STM32L151CB.
Configuration via soldering jumpers for USB, standalone or Raspberry PI.
Software from LoRaMac-node

This entry was posted on Thursday, July 17th, 2014 at 1:00 pm and is filed under ARM. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “SX1278/SX1276 (RFM98W/RFM96W) LORA module”

  1. Alan says:

    For those who want to know what “Lora” is: LOng RAnge RF communication.
    Forget the ionosphere and hams talking half-way around the world: that’s HF (under 30MHz) and these chips [SX1272] start at about 800MHz.

  2. Manuka says:

    Semtech’s spead spectrum LoRa™ is indeed looking a UHF wireless data game changer! Both bare & CPU fitted modules covering down to 433 MHz (along with friendly USB linked setup software) already are available from several Chinese outlets – Appcon, Dorji & HopeRF etc. US giant MicroChip has just taken LoRa on too ! Ranges an order of magnitude greater than traditional modules ARE being verified, with several km typical in urban areas (rather than the usual several 100m).

  3. MeshedPi
    I have build similar one, similar module for IoT Long Range. But just with FOUR transceivers, for Diversity reception, as Repeater, Gateway or Hub, Localization via triangulation etc.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: Awesome build... reminds me of an old time travel argument: If UFOs are a kind of time travel device, then why haven't someone from the...
  • pankaj: can i make soldering paste with cationic rosin
  • pankaj: i want to make soldering paste . i dont have water white rosin , i have cationic rosin . pls tell me is this cationic...
  • Chip Stewart: Am I too late?
  • Sebastian: Yes please!