Categories

GTP USB lite SMD board

Posted on Wednesday, February 26th, 2014 in PIC, USB by DP

20140122-182905

Here’s a PIC programer SMD board for the GTP USB lite pic programmer by cmardone:

I created a pic programer smd board for the gtp usb lite pic programmer.

  • Was made using EagleCADSOFT 5.0
  • 2 layer board
  • 0603 footprint for most smd components !!
  • uses a 18F2550 SMD chip from microchip
  • has a mini-A USB connector
  • schematic , firmware , driver and gui for windows where taken from here
  • test status: Confirmed !!!!
This entry was posted on Wednesday, February 26th, 2014 at 1:00 pm and is filed under PIC, USB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “GTP USB lite SMD board”

  1. There is a new hack for this programmer !!

    Now is posible to load a firmware from usbpicprog.com making this programmer compatible with Mac , linux and windows…

    here is the link
    http://www.valpoder.com/?p=268

  2. Norman says:

    where can I find the schematics that you are using? I’ve looked at the schematics that you link to on ali3nworld blogspot but it seems to miss a few details. I would loke to know for example what are the LEDs connect to.

  3. i added the schematics for both programmers in my blog:::
    http://www.valpoder.com/?p=268

    in gtp usb lite : leds are RB7 RB6
    in usb pic prog : leds are RC0 RC1 RC2

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • coppice: If all you have found so far is fake iphones, the next place you should visit is SEG in Hua Qiang Bei. Get out of...
  • Edward Cooper: Great article and good find on the markets! Any chance you can provide the locations of these places? I'm in Shenzhen at the moment and...
  • Dan: I'm up for one
  • TrickyNekro: Always in for another bunch! :-D
  • mol-1: Maybe this time !