Categories

Magic Mote wireless sensor v2

Posted on Wednesday, February 26th, 2014 in sensors, wireless by DP

PC02-front-smaller

Tom posted an update on his Magic Mote wireless sensor we covered previously:

Here is Version 2 of the Magic Mote PCB. The tactile switch is more accessible at the side of the board, the programming/serial header is now IDC6 compatible, and there is improved isolation of the ground plane under the watch crystal.

This entry was posted on Wednesday, February 26th, 2014 at 7:00 pm and is filed under sensors, wireless. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please