Categories

App note: Calibration of the ATtiny25/45/85 internal temperature reference

Posted on Sunday, June 23rd, 2013 in app notes by DP

ATApp

Here is an app note from Atmel describing how to calibrate the ATtiny internal temperature reference.

This application note describes how to calibrate and compensate the temperature measurements from the ATtiny25/45/85. It can also be used on other AVR microcontrollers with internal  temperature sensors. The temperature measurement is based on an on-chip temperature sensor that is coupled to a single ended ADC channel.

This entry was posted on Sunday, June 23rd, 2013 at 9:00 pm and is filed under app notes. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Kurt: It doesn't matter who my father was; it matters who I remember he was.
  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...