Categories

Another project-a-week: ATtiny85 programming shield

Posted on Monday, March 4th, 2013 in project logs by DP

ATtiny85 Programmer FRONT

This week Rwinscot shared his RickPAW ATtiny85 programming shield project in the forum:

Saw a couple implementations of the ATtiny85 programmer on Instructables… and decided to roll my own.

It’s bare-bones, but gets the job done. It works as a minimal Arduino shield and has headers for ‘jacking-in’ to the uC. Goals on this one are to keep the design inexpensive and experiment with different board shapes.

This entry was posted on Monday, March 4th, 2013 at 1:00 pm and is filed under project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Another project-a-week: ATtiny85 programming shield”

  1. mail@kaibader.de says:

    Nice design. Maybe mine is not as fancy as the programmer shown above, but a bit more versatile…
    http://www.kaibader.de/attiny-isp-arduino-shield/

    Kai

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...