Categories

ATX Breakout Board V1.1 Acrylic case V1 back in stock

Posted on Friday, February 1st, 2013 in ATX BB by DP

ATXBreakout Board case-W600

The ATX Breakout Board v1.1 Sick of Beige case is back in stock at Seeed Studio. This case is designed to be simple, cheap, and easy to assemble. The ATX Breakout Board is sandwiched between two laser-cut acrylic sheets, and the whole assembly is held together with aluminum screws and standoffs.

This is a minor update with the secondary ground and -5volt post holes cut, and a ventilation opening over the big resistor.

Check out our tutorial on how to customize Sick of Beige cases.

You can get one for $4 at Seeed Studio.

This entry was posted on Friday, February 1st, 2013 at 8:00 pm and is filed under ATX BB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...