Categories

PCB a Week 5: Oledy generic OLED breakout board

Posted on Monday, January 14th, 2013 in PCBs, project logs by DP

oledy-gerber

Mats continues his challenge of designing one PCB every week. In week 5 he came up with Oledy, a breakout board featuring 8 most common pitches for OLED display connectors, spanning from 0.5mm to 1mm.

The Oledy board is a 5×5 cm board meant to be cut in half ending up with two boards 2.5 x 5 cm. Each board have a two 16-pin headers that are connected to four arrays of 32 solder pads. All eight pad arrays are of different pitch to match different OLED displays. The piches are 0.50, 0.60, 0.62, 0.65, 0.70, 0.80, 0.845 and 1.00 mm

Via the forum.

This entry was posted on Monday, January 14th, 2013 at 7:00 pm and is filed under PCBs, project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “PCB a Week 5: Oledy generic OLED breakout board”

  1. Sleepwalker3 says:

    I want one :D

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Peter: Yet another Sunday!
  • Jack: Random comment from KM6MEE. Thanks!
  • KH: A lot of projects that we make will never be cheaper than commodity hardware. It's a choice that each of us will have to make...
  • Drone: @Cyk says: "Well, this is an application that I’d solve with an Android smartphone" BAD idea Cyk: Android Smartphone = Spy on Me Google!
  • Cyk: Well, this is an application that I'd solve with an Android smartphone. Used Moto G phones can be found on Ebay for ~€30, and thanks...