DIY Ferric Chloride etchant

Posted on Thursday, December 6th, 2012 in DIY, PCBs by DP

Here is a guide on how to make your own Ferric Chloride etchant. It’s a relatively simple process that only requires some iron, hydrochloric acid, and air. As the process uses acids please be careful, and do this only if you feel comfortable with it.

Get 20g of iron. This can be in the form of nails or steel wool. It’s best to use iron that’s rusting, that indicates it doesn’t have other metals like zinc or chromium that’s normally used to prevent rust. To the iron add 100mL of water and 100mL of 12M hydrochloric acid. The iron will start reacting with the acid to produce hydrogen gas and ferrous chloride. If the reaction is proceeding too slowly for your liking you can heat up the mixture. A flask of cold water on top is useful to reduce evaporative losses.

Side note: If you already have access to hydrochloric acid and hydrogen peroxide you might be better off just using that for etching. Here is an instructible on how to mix it up, and why it might be better then Ferric Chloride.

Via PCBheaven.

This entry was posted on Thursday, December 6th, 2012 at 1:00 pm and is filed under DIY, PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

7 Responses to “DIY Ferric Chloride etchant”

  1. Rick says:

    I think you mean ‘etchant’? I read the article looking for a DIY spell.

  2. logical says:

    Hydrochloric acid is also an ingredient in meth so don’t act suspicious when you buy it.

  3. Chuckt says:

    Logical, lol. Some companies like the one I work for don’t ask and we’ve shipped stuff to people’s houses who were working on stained glass so you can tell them it is for electronic work.

  4. macpod says:

    Hmm, I’m going to need more ferrets.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments