Categories

Workshop Update for December 4th, 2012

Posted on Tuesday, December 4th, 2012 in Workshop Update by DP

Progress continues on the QFP protoboards. We rearranged the design a little as space became a premium. The goal of this board’s update was to extend each component’s pad length. To achieve this we had to pull some pretty neat tricks to make it all fit.

This entry was posted on Tuesday, December 4th, 2012 at 11:55 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Workshop Update for December 4th, 2012”

  1. Sleepwalker3 says:

    Any sort of USB connector available on there or is there a general area where perhaps one could be soldered?

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Pekka Akselin: This is ridiculous!? :-) We are back at 256(!) byte EPROMs that needed multiple, a handful, of voltages to run! :-(
  • KH: Let's try a back-of-envelope calc balancing energies. From MCP1700 datasheet, there are graphs for a 200mA load step. Estimate the energy shortfall as 12uJ. Say...
  • Daniel: It's been a week and my comment is still awaiting moderation. Apparently the CIA doesn't want their involvement known?
  • KH: Agree, so okay, I guess he must have learned from somewhere. 100nF and 1000uF is so far apart, that was jarring; it's more magic incantation...
  • Max: I have a suspicion the hefty electrolytic cap might be some sort of cargo cult carry-over from other RF-based projects - for instance, I've seen...