Categories

Workshop Update for November 30th, 2012

Posted on Friday, November 30th, 2012 in Workshop Update by DP

We’ve finalized our xQFP footprints. The pads in the old design were short, making soldering hard. The new design remedies that, and comes with our standard CC BY-SA license. The files are available in our Eagle library.

This entry was posted on Friday, November 30th, 2012 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

5 Responses to “Workshop Update for November 30th, 2012”

  1. Adrian says:

    How about combining the two footprints on opposite sides of the same PCB? Similar concept like this SOIC/TSSOP breakout board: http://store.oshpark.com/products/28-pin-soic-tssop-to-dip

  2. having unconnected lines in the middle of signal traces will probably have bad effects with high-speed signals.

    they will act as quarter wave opened line stubs, e.g. resonant bandpass filters.

    maybe that’s acceptable for a breakout board, because the signal frequency will never be so high… but whatever.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • coppice: If all you have found so far is fake iphones, the next place you should visit is SEG in Hua Qiang Bei. Get out of...
  • Edward Cooper: Great article and good find on the markets! Any chance you can provide the locations of these places? I'm in Shenzhen at the moment and...
  • Dan: I'm up for one
  • TrickyNekro: Always in for another bunch! :-D
  • mol-1: Maybe this time !