Ealge Parts: Combined surface mount and through-hole DIP socket

Posted on Wednesday, November 14th, 2012 in Eagle parts by DP

We wanted to make a footprint for a combined surface mount and through hole DIP socket. It’s a through hole socket with bent leads so it could be soldered in a surface mount process. This will be used in a secret project which will revealed next week in China.

This entry was posted on Wednesday, November 14th, 2012 at 7:00 pm and is filed under Eagle parts. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

4 Responses to “Ealge Parts: Combined surface mount and through-hole DIP socket”

  1. peter says:

    The return of the secret project(s). Can’t wait!

  2. Drone says:

    Sigh… DP is still stuck in Eagle. Embrace Open Source DP!! Cope with the CHANGE :-)

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Stephen Tinius: Thank you.
  • KH: Ah, the site sells boards, that's the reason. At least it's a XC6SL9 board that does not cost an arm and a leg, though it...
  • Max: While I understand this is more educational than practical in nature, I prefer my edutainment a lot more firmly grounded in economic reality. Sure, you...
  • KH: Using an alkaline coin cell down to 1.0V or under is a very bad idea anyway, unless you as the designer or manufacturer don't care...
  • KH: Farnell says TS1001 is no longer stocked. Not on RS. Digikey says it's obsolete. That said, there are a lot of nanoamp-class parts on sale...