Categories

7400 competition entry: Signal strobe

Posted on Tuesday, November 6th, 2012 in 7400 contest, contest by DP

Check out Matthew’s 7400 contest entry, a 74xx based signal strobe for emergencies, as well as search and rescue situations.

This a signaling strobe, an enhanced one with a siren. My device is built off of 7400 NAND Quad Gate, 2x 7476 J/K Flip Flop, 7432 OR Quad Gate and 4x 555 Timers. Now of course, there are a few passive components like capacitors, resistor, 5 volt regulator, LEDS, and several switches. All built on one large breadboard, but I believe this could be fabricated on a 2×4 PCB, maybe smaller

To be able to complete the project for the 7400 competition, I wasn’t able to find locally the I/R diodes or the high output LEDs that will be mentioned later. I will go over it POU, point of use, and a bill of material will be included at the very bottom.

Via the contact form.

This entry was posted on Tuesday, November 6th, 2012 at 5:00 am and is filed under 7400 contest, contest. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

2 Responses to “7400 competition entry: Signal strobe”

  1. Matt - Himself says:

    Awesome!!

  2. Destate9 says:

    I think you’re missing a clock there, bud

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: Awesome build... reminds me of an old time travel argument: If UFOs are a kind of time travel device, then why haven't someone from the...
  • pankaj: can i make soldering paste with cationic rosin
  • pankaj: i want to make soldering paste . i dont have water white rosin , i have cationic rosin . pls tell me is this cationic...
  • Chip Stewart: Am I too late?
  • Sebastian: Yes please!