Categories

Another toner transfer circuit board making guide

Posted on Thursday, October 11th, 2012 in DIY, tutorials by DP

Sometimes prototyping your boards needs to be done quickly. Etching boards at home is the quickest way to knock up simple designs. There’s tons of ways to do it, one of the most popular is the toner transfer method. A circuit design is laser-printed on glossy paper, then transferred to a clean copper board with a clothing iron.

This entry was posted on Thursday, October 11th, 2012 at 1:00 pm and is filed under DIY, tutorials. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Another toner transfer circuit board making guide”

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: That's a good one, ha ha. Let's see whether ST Microelectronics takes action. I can understand how this can be done legally, ARM is not...
  • Ja: Where these GD chips can be found? Everywhere I look I have found only STM chips.
  • Max: Well, there's your problem. Or rather, the problem with Arduino in general: a) not using interrupts for anything that can't wait, and b) using delay()...
  • KH: yield() instead of proper interrupt-driven code? Ewwwwwww... somebody please teach these Arduino folks proper AVR microcontroller programming!
  • Henry: Hope I win one thanks