Buy stuff

Categories

USB current and voltage tester designed on the DP5031 standard PCB

Posted on Monday, October 8th, 2012 in project logs, USB by DP

Here is TitanMKD’s USB current, and voltage tester designed on the DP5031 standard PCB. The board features 4 standard USB connectors, while voltage and current can be measured via 4mm banana terminals

For those interested in a cheap funny board to test USB current consumption/voltage or even check USB D+/D- and ID signal

The goal of our standard PCB format is to make it super simple to design a project that fits in a bunch of different cool, open source cases.

Grab our Eagle library or KiCAD board templates to use Sick of Beige PCB standard for your own projects.

Via the forum.

This entry was posted on Monday, October 8th, 2012 at 11:00 am and is filed under project logs, USB. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Daniel: Do I comment here or on FB?
  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?