Categories

Part Ninja perfboard build

Posted on Tuesday, October 2nd, 2012 in builds, Part Ninja by DP

Mikelelere wanted to play around with the Part Ninja, but he didn’t have one of our PCBs. He used a perfboard to build his own. His goal is to integrate ESR measurement:

I’ve just finished building the Part Ninja v1 on a perf board. It’s a little nice tool, and it’s great for identifying different BJTs and MOSFETS apart from other parts.

The Part Ninja is a electronic component testing tool. It identifies electronic components like transistors and FETs, determines the pinout, and measures basic specifications.

Via the forum.

This entry was posted on Tuesday, October 2nd, 2012 at 9:00 pm and is filed under builds, Part Ninja. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Edward Mallon: A teacher friend asked us for faster build that was less dependent on soldering because they didn't have the budget for that kit. So we've...
  • lostengineer: hahaha an entire article just saying to heat-shrink your wires or glue them if they might move around a lot. When did common sense die?
  • readybrek: They're tasty tasty very very tasty... they're very tasty.
  • hli: Sunday++
  • Chamod: Check on your buddy. Make sure they don't forget their lunchbox.