Categories

Another DIY GLCD clock built

Posted on Friday, September 7th, 2012 in project logs by DP

Scorpia built Ezflyr’s GLCD clock project we blogged about here. After some debugging, and help from Ezflyr, he was able to get it up and running.

The project is based around the 75×52.7mm 128×64 Graphic LCD. The time keeping is delegated to a battery-backed Dallas DS-3231 RTC. A PIC 16F876A is used to tie it all together. The PCB was designed to fit nicely behind the display.

Via the forum.

This entry was posted on Friday, September 7th, 2012 at 11:00 am and is filed under project logs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Another DIY GLCD clock built”

  1. serkan karaaslan says:

    Nice work but how can I get the schematic-firmware and codes? Thank you, awaiting your soonest reply..

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: TPS62200 will get him to under 15uA, a bit better than the 20-30uA he mentioned. I would try the same thing. Switch some resistors in...
  • KH: Yeah, it's an end-user thing. Very few people would spend hundreds of hours on this kind of project and sustain it. It's more or less...
  • Max: Not quite a dinosaur if you've seen Big Hero 6 though... wait. You've watched it with your kids, didn't you? That's cheating...! ;) One of...
  • Edward Mallon: A visiting researcher dropped by our humble basement workshop with questions about the physical skill level students would need if they added one of our...
  • KH: And that looks really expensive... Only browsed the vid though, I'm an dinosaur so I had the sound off too. Nice of him to open-source...