Nixie tube first light

Posted on Friday, September 7th, 2012 in #liveupdates by Ian

Nixie tube supply is working great at 180 volts and 12k anode resistor.

This entry was posted on Friday, September 7th, 2012 at 9:47 am and is filed under #liveupdates. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

9 Responses to “Nixie tube first light”

  1. J. Peterson says:

    180V? Finally, a prototype that lives up to the “Dangerous” name : )

  2. Sjaak says:

    :$ nixies

    • Ian says:

      Trying to get the little VFD tubes going. Do you remember what we did to get it going? I put 12volt in with 560ohm to filament and other side to ground (as shown in schematic), but not sure what to with the segments. Tried +12 and gnd but no glow. Web has been particularly unhelpful.

      • vimark says:

        try to swap the polarity of the filament, +12 should be connected to the segment with its gnd on the filament’s gnd too.

  3. bluehash says:

    Love it!

  4. Filip says:

    all we need is a DP flash destroyer with nixies :) with an added function, once it burns out the flash….it drives 180v trogh the chip…

  5. Wayne says:

    There is a reason why nixies were dropped from use, HIGH voltage and danger to experimenters may have been it! :P . I remember them operating on substatially less voltage. Hmmm…

    • Ian says:

      While not as safe as an LED, I dont consider 180-240V DC from a little booster to be super dangerous, only potentially dangerous. People who can operate laser, table saws, and/or blenders should be ok :D

      • Matseng says:

        It can hurt you a bit but should be quite safe for most people. It seems like 0.5 Joules is classified as an “intrinsically safe” level of energy. Strangely enough for both electrical energy (electric fence or a strobe beacon) as well as kinetic (as from a BB gun)….

        A 2.2 uF capacitor charged to 200 volts only have 0.04 Joules of energy stored. So unless the nixie smps have a HV cap of more than 25 uF they should be considered safe.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please