Workshop Update for August 31st, 2012

Posted on Friday, August 31st, 2012 in Workshop Update by DP

Made changes to Open Hardware Summit presentation based on comments, thanks everyone!

Received second H1N recording device for our workshop video at Sjaak’s place this weekend.

Making contact with New York City hackerspaces for our upcoming visit. If you’re planning to go to Maker Faire or Open Hardware Summit in NYC you are welcome to join our tour of shops and hackerspaces.

Working on ATX PSU v2 using KiCAD.

This entry was posted on Friday, August 31st, 2012 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

3 Responses to “Workshop Update for August 31st, 2012”

  1. Arup Basak says:

    \/\/|-|() 700|< 0x1337?

  2. teslatree says:

    Happy to see you use kicad. The workflow seems a little strange the first few minutes, but now it all makes sense. Check out fped, a scriptable footprint editor.

  3. Paul says:

    +1 for Kicad. Finally open source software for open source hardware. And workflow is actually very nice and easy.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • KH: Using an alkaline coin cell down to 1.0V or under is a very bad idea anyway, unless you as the designer or manufacturer don't care...
  • KH: Farnell says TS1001 is no longer stocked. Not on RS. Digikey says it's obsolete. That said, there are a lot of nanoamp-class parts on sale...
  • Peter: Sunday--
  • Chris Brightly: Best of luck to all, including the wayward prototypers yet to post!
  • Wolfi: o/