Buy stuff

Categories

First board manufactured using a laser cut solder stencil

Posted on Friday, August 31st, 2012 in dev boards by DP

Taylan tweeted:

First board manufactured using [a laser cut solder] stencil.

This entry was posted on Friday, August 31st, 2012 at 9:00 pm and is filed under dev boards. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Craig B: Shouldn't the default be 00xxx010? Note that bit 0 appears out of order in the documentation. In that case I think the initial value is...
  • JJM: From the datasheet extract you are showing, the power up status should be 00xxx010, not 000xxx01. Bit numbering is misleading since 'measurement resolution' is apparently...
  • Jan Ciger (@janoc200): Hmm, that could actually explain why the three sensor IMU breakout I have bought a few years ago had all sorts of issues - I...
  • Travis: Is it preset to the windows 3 fingered salute?
  • Glenn: What a cool idea !