Laser cut acrylic power supply case uses ATX breakout board

Posted on Wednesday, August 29th, 2012 in cases by DP

Systemstech posted pictures of a case he built for his ATX Breakout board.

You can get a ATX Breakout Board v1.1 for $14 at Seeed Studio.

This entry was posted on Wednesday, August 29th, 2012 at 11:00 am and is filed under cases. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Nathan Johnson: 100 channels. Not many are legal in any given area. Be sure to comply with local laws.
  • William Brodie-Tyrrell: It's getting to the point where it's cheaper and definitely easier to use a Pi Zero or similar and a $20 3G USB dongle. Power...
  • KH: IIRC most of the actual operating system of modern HDDs is in one of the platter(s); the stuff on the 25VF010 is a bootup firmware......
  • Trev: I don't know of any inexpensive 3G modules (prices start around $US 50), but it does explain why 2G modules are relatively inexpensive by comparison....
  • Zonie: This site Rocks!