Categories

Via options: Tenting, capping, plugging, or filling

Posted on Friday, August 24th, 2012 in how-to, PCBs by DP

From comments on our earlier Poision via effect in manufacturing post, Bearmos shared an article about via options in PCB manfacturing:

On the PCB side of things, here’s an article from a PCB fab that goes over a couple of the via options: via tenting, caps, and plugs (PDF!). This just landed in my inbox this morning – what interesting timing. . .

Thanks Bearmos! Via the comments.

This entry was posted on Friday, August 24th, 2012 at 9:00 pm and is filed under how-to, PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Bob: Jambalaya rocks.
  • KH: I should point out something... well, lead acid car batteries are designed to be well-charged all the time. The plates (which are patterned and thin)...
  • David Haile: You are a smart person and absolutely correct. That kind of current needs a lead acid car battery behind it. Still, it does have its...
  • KH: The solution discussed in the linked article is wrong. It's a largish Lipo (2500mAh) and he thinks 77uA is acceptable... ha ha ha ha ha....
  • Dave: I never had to opportunity to learn or use this stuff when I was in college (I'm sooo old that op-amps were just being developed...