Categories

Workshop update for May 15th, 2012

Posted on Tuesday, May 15th, 2012 in Workshop Update by DP

Today we continue to prepare for the Bay area Maker Faire. We also made the workshop video today instead of Thursday, it’ll be about Maker Faire of course. If you subscribe to our YouTube channel you might even be able to preview the video early.

On the design side we continue to adjustment an unnamed project for a final revision. We had some issues with clearance on the rotary encoder knobs and some headers.

We are pushing the Part Ninja firmware for a release. The testing functions have been rewritten to be more modular, and easier to maintain. This will be followed with documentation on how each test is conducted, and the formulas used to determine key values.

In the office we did the payroll cause it’s the 15th, and added Evola to our distributes wiki list.

This entry was posted on Tuesday, May 15th, 2012 at 11:00 pm and is filed under Workshop Update. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

One Response to “Workshop update for May 15th, 2012”

  1. r3tikus says:

    good luck in your travel, I wish I could go. :(

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please