Categories

Solder paste stencil review

Posted on Monday, April 23rd, 2012 in kit biz by DP

Check out this solder paste stencil review [PDF!], including differences between laser cut and chemically etched stencils:

Page 11 has nice photos comparing three stencil production methods, chemical, laser, and electro-form. There is good information, scattered through-out. pg 15 to paraphrase “go slower!” seems a key pattern, it’s repeated for other things like the spreader speed.

Via the forum. Thanks AndThen!

This entry was posted on Monday, April 23rd, 2012 at 1:00 pm and is filed under kit biz. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Sjaak: In theory the buspirate can also do SWD or JTAG as it just wiggling some pins. I dunno if the speed and memory is sufficient...
  • Drone: Aw, how-come Bus-Pirate can't do all this too?
  • Siddharth: Grate
  • jeanmarc78: hello
  • KH: So I guess, don't mind us dinosaurs too much. Someone like me will get triggered by some of the things Arduino folks do. There's just...