Categories

Box of new PCBs

Posted on Tuesday, February 7th, 2012 in PCBs by DP

 

 

A box of PCBs just arrived from Seeed Studio’s Fusion PCB service. The XT-IDE adapter V2 board is now available in our Free PCB drawer. The board was designed to allow XT type vintage computers to use newer IDE type hard drives.

XT-IDE Adapter v2 is available now in the free PCB drawer.

This entry was posted on Tuesday, February 7th, 2012 at 9:00 pm and is filed under PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

6 Responses to “Box of new PCBs”

  1. Arup says:

    I didn’t read the full forum topic on this. But a stupid question comes, Why not SATA? IDE is almost obsolete nowadays.

  2. Al Hartman says:

    Isn’t there any way to buy one of these either in kit form or assembled?

  3. Al Hartman says:

    Nothing is as easy as clicking a link to have an assembled and tested board shipped to you. Especially if you are like me, a person with shaky hands and poor vision.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...
  • KH: Someone with a PIC16F1459 project, well you don't see these every day. Methinks he repeats the USB 2.0 thing too much; this might mislead people...