Arsenijs over at Hackaday.io writes: This tutorial was done on Windows. Authors claim it could also be used on Linux by using Mono, but I haven’t tried and don’t understand a lot about Mono to see what could be done. I am switching to Linux nowadays, so I’d be very grateful to anybody that’d make instructions […]
Tag Archives: panelizing
EAGLE: Panelizing made easy
Sjaak shared a tip for panelizing PCB boards in Eagle: Panelizing is done by machining a slot between two or more boards, but keep them attached by a small amount of PCB material (mousebites). I used to do it by hand: generated all the schematics into multiple sheets and then route the board and finally […]
What happens when a V-groove hits your copper pour
Panelizing multiple PCBs onto a single panel is a cost effective way of prototyping. V-groves are usually used to separate the different PCBs, making it easy to snap them off. The picture above depicts what happens when the V-grove hits a copper pour such as a ground plane. Anyway, back to the topic. You usually […]