Categories

Posts Tagged ‘assembly’

DirtyPCB Crane controller

Monday, June 22nd, 2015

In this video MatthiasW demonstrates a complete DirtyPCB assembly of Crane controller: Nevertheless I was quite happy with the overall quality of the boards so I immediately started assembling the crane controller. I took a time-lapse video of the soldering and the first test of the board, which worked out...

Tags: ,
Posted in DirtyPCBs.com | 3 Comments »

DigiPot assembled

Thursday, January 17th, 2013

Matseng continues his challenge of designing one PCB a week. His week 2 board, the DigiPot, has arrived and he assembled it. He did run into problems soldering the connectors which he unfortunately clustered under the encoder. Soldering them was very hard and the leads on both the pin headers...

Tags: , ,
Posted in project logs, testing | No Comments »

Recent Comments

  • Max: Hey, good job quoting as an abstract something the author writes about someone else's project... For the record, I do appreciate the proper attention to...
  • imqqmi: Also interesting to note that arduino's use the DTR signal to reset the device. I found this out because repetier was able to do this...
  • Kevin: A bit sad that you are using a knock off Saleae device unless you are not using Saleae software.
  • Max: For the Haxxor Edition he could add a Morse-to-scan-code translator to the code in the PIC (where the L337 Haxxor Special also accepts Unicode code...
  • KH: Someone with a PIC16F1459 project, well you don't see these every day. Methinks he repeats the USB 2.0 thing too much; this might mislead people...