Buy stuff

Categories

Build your own IoT/MQTT node for less than $2

Posted on Wednesday, July 3rd, 2019 in how-to by DP

20181230_174619-600

Albert David writes, “This blog explains how to use ESP-12F module without the need of a base board but with minimal set of components.”

See the full post on his blog.

This entry was posted on Wednesday, July 3rd, 2019 at 11:39 pm and is filed under how-to. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...