Categories

1750Hz tone generator

Posted on Tuesday, June 4th, 2019 in DIY by DP

tone-burst-generator

Dilshan Jayakody published a new build:

The 1750Hz tone bursts are often used to trigger repeaters. There are several methods to build 1750Hz tone generators which including TC5082 divider, using MCUs, etc.
In this post, I present another 1750Hz tone generator which I built using 74HC4060 high-speed 14-stage binary ripple counter and 7.168MHz crystal. In this design, 74HC4060 is used to drive the crystal and divide its output by 4096. By using 7.168MHz crystal, this circuit produces 1750.0Hz square wave output with a 50% duty cycle.

See the full post on his blog.

This entry was posted on Tuesday, June 4th, 2019 at 12:13 pm and is filed under DIY. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please