Categories

Building a direct conversion receiver

Posted on Tuesday, December 11th, 2018 in DIY, how-to by DP

IMG_20181208_002739

Ryan Flowers over at MiscDotGeek posted a how-to on building a direct conversion receiver:

In the first installment of this series, we discussed why we’re building a Direct Conversion receiver and talked about some basic ideas. In this installment, we explore what it takes to make the leap from a printed schematic to something physical that works. Follow along!

More details at MiscDotGeek.com.

This entry was posted on Tuesday, December 11th, 2018 at 10:55 pm and is filed under DIY, how-to. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • readybrek: Anyone got a any recommendations for a budget-priced hot air station?
  • William: lol I'm happy to waste 3c for each program/debug cycle... but probably not the time spent soldering a new device down to a proto board!...
  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...