Categories

Desoldering station

Posted on Thursday, May 3rd, 2018 in hacks by DP

PICT4929_-600

Stynus writes:

Some time ago I bought a lot of Weller soldering irons at an auction for cheap. Between these where a few DSX 80 de-soldering irons.
I also had an old Weller IG101 solder station (bought earlyer from another hobbyist), unfortunately I had no iron for this one and the DSX 80 could not be connected to this one. Time to convert the IG101 to newer standards.

More details at ElektronicaStynus homepage.

Check out the video after the break.

This entry was posted on Thursday, May 3rd, 2018 at 11:44 pm and is filed under hacks. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please