Categories

Alexa (Echo) with ESP32 and ESP8266 – Voice controlled relay

Posted on Tuesday, March 27th, 2018 in tutorials, wireless by DP

p-esp8266-esp32-alexa-circuit-600

Rui Santos writes, “In this project, you’re going to learn how to control the ESP8266 or the ESP32 with voice commands using Alexa (Amazon Echo Dot). As an example, we’ll control two 12V lamps connected to a relay module. We’ll also add two 433 MHz RF wall panel switches to physically control the lamps.”

More info at randomnerdtutorials.com.

Check out the video after the break.

This entry was posted on Tuesday, March 27th, 2018 at 11:53 pm and is filed under tutorials, wireless. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please