Categories

PCB Businesscard Nextgen: NFC enabled

Posted on Tuesday, October 3rd, 2017 in PCBs by DP

bc_new-1080x675

A followup to the PCB business card post,  Sjaak writes:

Designing a PCB business card seems to be the go-to for a hobbyist electronic engineers. Most people design either a passive PCB, USB HID/MSD device or battery powered LED frenzy. Uptill now I haven’t seen any cart that has a RFID, not even regular paper ones. As usual it started with a brainfart and I designed a burner PCB. Usually I try to design a perfect one which in the end needs at least two revisions to make it perfect. Now I tried a different route and designed a small pcb with solderjumpers and lot of bodge options

More details at smdprutser.nl.

This entry was posted on Tuesday, October 3rd, 2017 at 2:22 pm and is filed under PCBs. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Leave a Reply

Notify me of followup comments via e-mail. You can also subscribe without commenting.

Recent Comments

  • Joe Desbonnet: Ya, I can recommend the low melting point solder. I used brand 'ChipQuik' and it's amazingly easy to use.
  • Jerome: I need a new BusPirate for the Fablab ;) Many thanks!
  • Max: Seems like an unexpectedly violent way to remove the chip indeed. A hot air station should of course do the job just fine, but in...
  • jose: Part removal described here is pure butchery, the cheapest hot air station will do a fast and clean job removing the QFP, heat air to...
  • Cody: Yes please